Sunt foarte frumoase mesele, dar cred ca sunt cam scumpe, parca atat era si una Mazurenko.
Pei am vrut de curiozitate sa vad unde fac ei livrari, iar rezultatul a fost chiar amuzant... Fac livrari doar in SUA si in Israel...
Ideea este ca atunci cand iti cumperi ceva voluminos si greu, ca o masa de skandenberg, transportul te rupe (chiar daca masa se poate dezasambla)... Deci cei din SUA nu prea cred ca isi comanda mese Mazurenko, exact cum nici noi nu ne cumparam mese din SUA... Eu le-am pus "just for show"...
Cel mai ieftin iesi daca iti poti construi singur o masa, sau daca vorbesti cu un meserias roman sa ti-o faca...
AAA & WAF Armwrestling Table Specifications" Section 2 – Equipment Specifications2.1 TableSit down: 28" from floor to top of table.
Stand-up: 40" from floor to top of table.
All other specifications are identical for both sit down and stand-up table tops.
2.2 Table top 36" across and 26" deep.
2.3 Elbow Pads 7"x 7" square shape. 2" thick, made of heavy high quality foam
material, covered with a vinyl/rexin type cover. The foam and covering can be attached to a 1/8"
metal sheet, 7"x 7" with two threaded bolts 1/4" diameter x 1 3/4" long, welded to the bottom to be
able and attach your elbow pads to the table top.
A line, either painted, upholstered or taped from hand grip to hand grip to establish center of the
table will always be used at WAF tournaments.
2.4 Touch Pads14" long x 4" high. Made of good quality touch pad
2.5 PlacementElbow pads should be set 2" from their respective edge.
They should overlap each other by 1/2 to the right of center for a right arm table and overlap each
other by 1/2 to the left of center for a left arm table.
2.6 Touch PadsShould be on an angle, 5" out from the inside corner of the elbow
pad to the inside corner of the pad and 1/2" from its respective edge measured to the outside
corner of the pad. Running at an angle towards the hand peg it should measure 2 3/4" from the
hand peg to the outside corner of the touch pad.
If it’s for a right arm table, these measurements should be made on the left side of the elbow pad
and reversed if it’s a left arm table.
2.7 Hand Pegs Should be placed midway at 13" on each edge of the table, 1" in from the edge.
The peg itself should be 1" in diameter and 6" high form the table top.
2.8 SeatsThey should be 18" square and 18" from floor surface to seat top surface. The front edge should
be exactly in line with the table edge. The seat and table should be secured to a platform or floor.
2.9 MaterialThe best material to use is square tubing although tubular steel, flat iron or angle iron may be
used, but not more than 2" in diameters or width. The table top and seat top are normally made
of 3/4" thick plywood.
The table top and seat may have a thin sheet of foam, covered with vinyl/rexin type material to
add a comfortable finished look. No plexi-glass or reflective tape is to be used on the table top or
seats. "
_______________________________________
REAMINTESC CA: 1" = 2,54 cm